OK, the jokes on me. You were not trying to pull one on April fools day. Your reply was Volt_humid, <[128, ...... which seemed that it's looking for a number smaller than the search number, which...
The HIH-4000 Humidity Sensors has an output voltage which must be referenced to percent humidity. My DS2438 is reading the voltage output of the humidity sensor. I then need to use a lookdown table...
I found out the hard way that not all HC-05 modules work the same. Use the version AT command and look for modules with the latest firmware versions. Try to establish a serial communication first...
just a thought too..... it is a lot of technology for the price, but sometimes these types of things, probably from China don't meet expectations.... but sometimes they are good!!!
there are a bunch of these types of things with your I and V range. Thats why I was wondering if your voltage was like 200+ volts or 50-80 amps.
.
.
9957
Published on - 27th May 2010 02:01
Number of Views: 11972
This is an effort to help users understand how the I2C command works by comparing it with SHIFTIN/SHIFTOUT. A serial EEPROM, 24FC1025 will be used in the example.
Re: Lookdown2 not working!
OK, the jokes on me. You were not trying to pull one on April fools day. Your reply was Volt_humid, <[128, ...... which seemed that it's looking for a number smaller than the search number, which...
MOUNTAIN747 Yesterday, 13:56