If you expect the signal to swing between 0 and +5V then set the trigger level to somewhere around 2.5V.
As with input coupling the trigger coupling can usually be set to either AC or DC. Perhaps...
Published on - 27th May 2010 02:01
Number of Views: 8746
This is an effort to help users understand how the I2C command works by comparing it with SHIFTIN/SHIFTOUT. A serial EEPROM, 24FC1025 will be used in the example.
Re: Scanning encoder debounce on new scope
Nice chip! I did not knew that one although I am of the CMOS era!
Ioannis Today, 20:14Anyway, since you master the art of software, I think is waste of money to add hardware when you can debounce in software.
...