could do.........
1)
'
restarting:
pause 1000 ............... wait a second or 2 to reset all
@ RESET
'
or 2)................
if all slaves are on same 5 or 3 volt supply, then use a small...
you could do in software..... send out to one or all listeners a command to goto a restart routine like.... which "provides a way to execute a MCLR in software"
,
,
,
restarting:
@ RESET
I ended up with this design, using tri-state pin on master to reset all the slaves when required. This will not be used for programming the slaves, only resets.
Published on - 27th May 2010 02:01
Number of Views: 8739
This is an effort to help users understand how the I2C command works by comparing it with SHIFTIN/SHIFTOUT. A serial EEPROM, 24FC1025 will be used in the example.
Re: Multiple PICs on usart network
Me too. But if I removed my post, the thread closed again.
Demon Today, 01:05:)