The USART section in the datasheet for your device will tell you if you should set/clear the TRIS bits for the TX/RX pins.
If the chip supports open-drain mode then you just need to setup the TX pin...
Well the carpet is one thing. Even if you just walked the room and returned back to you chair (even worse if it has suspension), then you may well have charged enough to destroy the chips.
I "like" the 16F1937, but I have no allegiance towards it (I only have 15 on hand, I'll keep them for "something else"). :D I'm starting the slow/annoying process of choosing another PIC, with...
Published on - 27th May 2010 02:01
Number of Views: 9761
This is an effort to help users understand how the I2C command works by comparing it with SHIFTIN/SHIFTOUT. A serial EEPROM, 24FC1025 will be used in the example.
Re: Framing error if I disable transmitter after shift register is empty?
The USART section in the datasheet for your device will tell you if you should set/clear the TRIS bits for the TX/RX pins.
tumbleweed Today, 14:22If the chip supports open-drain mode then you just need to setup the TX pin...