Tip: When you think you're doing something wrong and spend countless hours trying to generate a 3D model on JLCPCB:
9685
Stop tearing out your hair, browse the part and check the 3D model in...
The programming spec document for the 12F508 states that the min VDD for programming and bulk erase is 4.5V, so I'd increase that just to be safe....
tumbleweed Yesterday, 13:19Glad you got it working!
Yeah, that stand alone revive of Pickit application is my favorite! Love it! Fast, compact and easy to use.
I think you cannot ged rid of the MPLABX as the PBP needs...
Got it worked out!
Again a probably another rookie mistake...Solution was to increase the VDD to 4V! minimum. (software does recommend 4.5V) but 4 seemed to work fine.
Thanks Ioanins for the...
Thanks Henrik,
well, you nailed it, and I don't know why. I deleted the original code and inserted yours and it compiled fine. Just for fun I'll look at the ascii code originally there and see if...
Hi Paul,
The following compiles here, using PBP 3.1.6.4 and MPASM 5.87:
recvoff:
RCSTA1.7 = 0
while ! TXSTA1.1 :wend ...
Hello Henrik,
you and I have talked about this code a few times now. I had to change my name to protect the guilty! Actually I lost my original password and tried to recover the password but never...
That code sure doesn't compile but it's not because of RCSTA1.7=0 but rather END SELECT. If I remove END SELECT the reset does compile here.
Since you claim it compiles if you comment out RCSTA1.7=0...
Here is the code listing. The compiler complains about the RCSTA1.7 = 0 command. If I comment it out, the rest of the code compiles fine. The error message is "bad expression"
code:
recvoff:...
loop:
Re: JLCPCB ordering tip
Got a lots of tracks? Consider the over/under ™ technique:
Demon Yesterday, 21:269688
:D