I wanted to give a little update about a machine built and updated over the past few years and say thanks to all the answered questions I had programmatically when I got a little stuck.
A single...
so, I have made a exhaust fan timer with 1 mom button that will.... depending on press duration do..
----- >50ms and < 2seconds..... run fan for the programmed time of 15, 30, 60 or 120 minutes...
Amgen - Thanks for your input. Yes, I have tried both Mode 0 and 1 with no luck. I have also tried reversing the SCS pin (low, shiftout, high as opposed to high, shiftout, low) and nothing there...
Yes, I did set ADCON1 and no, I have not used a scope on this yet. Here is the entire code. I am simply trying to initialize the driver and run a stepper back and forth with 2 LEDs that indicate...
Hmm...PortA...have you disabled the analog functions (ADCON1 and CMCON registers, I believe)?
Have you verified (logic analyzer or scope) that the expected data does appears on the pins?
Competitions are subject to the privacy policy and website terms and conditions of picbasic.co.uk, owned and controlled by Crownhill Associates Limited (“Crownhill”).
The following rules shall apply, together with any instructions or rules specific to any current competition. By entering any of the community run competitions, you are deemed to have accepted the following:
...
Common Development and Distribution License (CDDL) is a free software license, produced by Sun Microsystems, based on the Mozilla Public License (MPL), version 1.1.
Menu
Re: Automated Machine with PIC18F4431 and PBP
Nice job!
Ioannis Today, 13:53Thanks for sharing what PBP can do!
Ioannis