The design is based on a classic switch (On/Off) but if I understand correctly, in special cases, the push button should be in a specific state and user is not allowed to change that.
not sure if I am understanding what you need, but if you need an indicator that the mechanism is in one position or another then a hall effect switch is just a simple 'proximity sensor'..... when the...
If you're using interrupts on either end then you shouldn't use SEROUT/SERIN as interrupts will upset the timing.
You should use the hardware HSEROUT/HSERIN routines, but then you will have to use...
I guess then, the sending device is interrupted by the USB routines while sending and as a consequence the transmission of RS-232 at that time is corrupted.
So I have a need to override a pushbutton (from ON to OFF) and came up with this concept; a solenoid piggyback on a pushbutton switch with a 3D printed cap held by a strand of wire.
...
Competitions are subject to the privacy policy and website terms and conditions of picbasic.co.uk, owned and controlled by Crownhill Associates Limited (“Crownhill”).
The following rules shall apply, together with any instructions or rules specific to any current competition. By entering any of the community run competitions, you are deemed to have accepted the following:
...
Common Development and Distribution License (CDDL) is a free software license, produced by Sun Microsystems, based on the Mozilla Public License (MPL), version 1.1.
Re: New project - MSFS C++ USB interface
The design is based on a classic switch (On/Off) but if I understand correctly, in special cases, the push button should be in a specific state and user is not allowed to change that.
Ioannis Today, 21:38Ioannis