If you keep messing up the "comma-separated" file prep like I do (the SAVE feature from Open Office is not smooth), consider using a script if you are I.S. savvy.
If you connect a logical analyzer to the serial lines, you know for sure if data is being transmitted or not. That would have saved you a lot of time. I always put in my PCB designs a testing point...
Okay, I think I might have solved this one. I didn't have the TRIS of the transmit pin configured as an output. I was under the erroneous impression the UART controller trumped control of any port...
I was originally planning on making 2 sets of MCP23017 circuits; 1 for input with debounce, 1 for output. But even with JLCPCB it comes out to $1 / PCB. I'd like to lower my cost more, and not have...
Use a logical analyzer to see what's coming out of the chip. Compare the output of the SEROUT2 to the output of the HSEROUT2 using the logical analyzer. You might think that your output is 115200,...
I've set the hardware config totally manually from the datasheet and via PBP defines (suggested in the supplementary document PIC18FxxK42_notes) and many hybrids of the 2 methods.
Competitions are subject to the privacy policy and website terms and conditions of picbasic.co.uk, owned and controlled by Crownhill Associates Limited (“Crownhill”).
The following rules shall apply, together with any instructions or rules specific to any current competition. By entering any of the community run competitions, you are deemed to have accepted the following:
...
Common Development and Distribution License (CDDL) is a free software license, produced by Sun Microsystems, based on the Mozilla Public License (MPL), version 1.1.
Re: JLCPCB ordering tip
If you keep messing up the "comma-separated" file prep like I do (the SAVE feature from Open Office is not smooth), consider using a script if you are I.S. savvy.
Demon Today, 03:02This is what I do to prepare PCBs...