not sure if I am understanding what you need, but if you need an indicator that the mechanism is in one position or another then a hall effect switch is just a simple 'proximity sensor'..... when the...
amgen Today, 21:30If you're using interrupts on either end then you shouldn't use SEROUT/SERIN as interrupts will upset the timing.
You should use the hardware HSEROUT/HSERIN routines, but then you will have to use...
I guess then, the sending device is interrupted by the USB routines while sending and as a consequence the transmission of RS-232 at that time is corrupted.
Ioannis
Maybe you can use a small stepper motor with linear motion like the ones on the CD head mechanism?
Like this one...
I've never used those types of switches before. Do you have a link?
I need a latching pushbutton switch to simulate these controls. They have to remain down when pressed ON, and pop out when...
One of the suppliers that had quoted me for that switch with the red shaft has a model with 100gf to operate. The model I am testing now uses 330gf.
It would be easier to use that switch cause I...
Hall effect switch with small magnet or if there is magnetic field around solenoid coil that the hall effect device can sense
amgen Yesterday, 18:36So I have a need to override a pushbutton (from ON to OFF) and came up with this concept; a solenoid piggyback on a pushbutton switch with a 3D printed cap held by a strand of wire.
...
The sending device has the typical 18F4550 USB setup and it is set to "Define OSC 48". The receiving device is set to "DEFINE OSC 16".
rsocor01 - 24th April 2024, 19:56
Re: New project - MSFS C++ USB interface
The design is based on a classic switch (On/Off) but if I understand correctly, in special cases, the push button should be in a specific state and user is not allowed to change that.
Ioannis Today, 21:38Ioannis