Can only hope!!! I think it still has a market, just product is not being marketed and it's a difficult experience to get started with.... IE
Can't get my first code running...
Have given up...
i like to connect some critical or dangerous hardware to one of those pins, like the enable pin for the high power laser or the step input for the Z axis.
that way you really know when reprograming...
I connect the ICSP port on the PCB to the ICSP pins of the controller directly. The Pins in turn go to the rest of your circuitry via resistors so that you do not need programming jumpers to perform...
Jerson Today, 02:54SMD's that many is impossible to do it manually in reasonable time and with no errors!
When production is low and you have through hole components, these are assembled by hand. And this costs......
Yes you can reuse them but you need to be careful as to what circuitry you hang off the pins.
Most ICSP programmers have 4.7K pull-down resistors on the PGC/PGD pins and assume the pins will idle...
Yup, confirmed. I removed headers from BOM and CPL and those 2 fees went away, as well as an extra $3 or so for cost of headers about $13 + tax reduction).
Anyways, I've decided to install the...
Do I have special considerations to take when I reuse ICSP pins?
Do I need a jumper during programming if I have a device connected, like a resistor/LED?
(I couldn't find any REUSE PGC/PGD/ICSP...
I'm pretty sure we get hit with "engineering", "setup" and "stencil" fees everywhere.
I tried to limit the "extended components fee" by using Basic components when possible (resistors and...
Yup, first thing I do is match all components on JLC's inventory for a given footprint and input price, JLC part # and Manufacturer part # in my symbol editor (Kicad), as well as if it's a Basic part...
Demon - 15th June 2024, 23:32
Re: PBP and IDE/programmer
Rookie mistake should have had INTIO67 not RC for the clock!!
robertg Today, 07:06Ahhh