Thanks Henrik,
well, you nailed it, and I don't know why. I deleted the original code and inserted yours and it compiled fine. Just for fun I'll look at the ascii code originally there and see if...
Hello Henrik,
you and I have talked about this code a few times now. I had to change my name to protect the guilty! Actually I lost my original password and tried to recover the password but never...
That code sure doesn't compile but it's not because of RCSTA1.7=0 but rather END SELECT. If I remove END SELECT the reset does compile here.
Since you claim it compiles if you comment out RCSTA1.7=0...
Here is the code listing. The compiler complains about the RCSTA1.7 = 0 command. If I comment it out, the rest of the code compiles fine. The error message is "bad expression"
Published on - 23rd April 2010 19:39
Number of Views: 6320
1. How can I reference a BIT in a BYTE?
2. How can I reference a BIT in a WORD?
3. How can I reference a BIT in a BYTE ARRAY?
4. How can I reference a BIT in a WORD ARRAY?
5. How can I reference a BYTE in a WORD ARRAY?
...
Re: JLCPCB ordering tip
Got a lots of tracks? Consider the over/under ™ technique:
Demon Yesterday, 21:269688
:D