If you expect the signal to swing between 0 and +5V then set the trigger level to somewhere around 2.5V.
As with input coupling the trigger coupling can usually be set to either AC or DC. Perhaps...
Published on - 23rd April 2010 19:39
Number of Views: 6247
1. How can I reference a BIT in a BYTE?
2. How can I reference a BIT in a WORD?
3. How can I reference a BIT in a BYTE ARRAY?
4. How can I reference a BIT in a WORD ARRAY?
5. How can I reference a BYTE in a WORD ARRAY?
...
Re: Scanning encoder debounce on new scope
This can work just fine:
Ioannis Today, 06:571. Set up a timer interrupt at 10ms. Or even at 1ms and after ten int's do step 2.
2. Every interrupt read the buttons into the arrays. You can use a low priority...