I'd be more worried by the fact that signal swings negative and not positive :-)
Don't worry though, it looks like you have the input coupling set to AC on the scope. Set it to DC and try again.
Hi all !
I have a montage where I use 16F628A I/P with the settings below. Due to the price that has increased a lot and the unavailability (is it an older generation?) I would like to switch to...
Got it working, stupid datasheet....
Address is $88, not $44, as in datasheet.
Found that using
https://www.picbasic.co.uk/forum/showthread.php/20185-I2C-Ping-program
Then is straight forward...
what have you tried ?
i fumbled around a bit with a scd41 which has a similar modus operandi and managed to get it to work with i2cread/write commands eventually , trick was to send a dummy 0 write...
Does anyone have SHT40 example code?
I'm trying for 2 days, and no progress. Is it posible with i2cwrite, i2cread command?
Trying to do conversion and read data, all 0's. Trying to read serial no,...
Published on - 23rd April 2010 19:39
Number of Views: 6242
1. How can I reference a BIT in a BYTE?
2. How can I reference a BIT in a WORD?
3. How can I reference a BIT in a BYTE ARRAY?
4. How can I reference a BIT in a WORD ARRAY?
5. How can I reference a BYTE in a WORD ARRAY?
...
Re: Vevor SDS1104 4 channel scope
There's something hinky going on. Sometimes it won't scan the probes. I still haven't figured out what exactly.
Demon Yesterday, 22:09But I go though the MODES, eventually the RUN/STOP buttons goes red, I reset it...