I guess then, the sending device is interrupted by the USB routines while sending and as a consequence the transmission of RS-232 at that time is corrupted.
So I have a need to override a pushbutton (from ON to OFF) and came up with this concept; a solenoid piggyback on a pushbutton switch with a 3D printed cap held by a strand of wire.
...
By lowering the baud rate you're now allowing device B (and SERIN2) twice the time to receive the bits and assemble the byte.
That's probably what's helping a lot more than any line noise issue.
...
Published on - 23rd April 2010 19:39
Number of Views: 6120
1. How can I reference a BIT in a BYTE?
2. How can I reference a BIT in a WORD?
3. How can I reference a BIT in a BYTE ARRAY?
4. How can I reference a BIT in a WORD ARRAY?
5. How can I reference a BYTE in a WORD ARRAY?
...
Re: SERIN2 Receiving Wrong Data
I guess then, the sending device is interrupted by the USB routines while sending and as a consequence the transmission of RS-232 at that time is corrupted.
Ioannis Today, 11:35Ioannis