If you expect the signal to swing between 0 and +5V then set the trigger level to somewhere around 2.5V.
As with input coupling the trigger coupling can usually be set to either AC or DC. Perhaps...
Published on - 23rd April 2010 19:39
Number of Views: 6245
1. How can I reference a BIT in a BYTE?
2. How can I reference a BIT in a WORD?
3. How can I reference a BIT in a BYTE ARRAY?
4. How can I reference a BIT in a WORD ARRAY?
5. How can I reference a BYTE in a WORD ARRAY?
...
Re: Scanning encoder debounce on new scope
Nice chip! I did not knew that one although I am of the CMOS era!
Ioannis Today, 20:14Anyway, since you master the art of software, I think is waste of money to add hardware when you can debounce in software.
...