The design is based on a classic switch (On/Off) but if I understand correctly, in special cases, the push button should be in a specific state and user is not allowed to change that.
not sure if I am understanding what you need, but if you need an indicator that the mechanism is in one position or another then a hall effect switch is just a simple 'proximity sensor'..... when the...
If you're using interrupts on either end then you shouldn't use SEROUT/SERIN as interrupts will upset the timing.
You should use the hardware HSEROUT/HSERIN routines, but then you will have to use...
I guess then, the sending device is interrupted by the USB routines while sending and as a consequence the transmission of RS-232 at that time is corrupted.
So I have a need to override a pushbutton (from ON to OFF) and came up with this concept; a solenoid piggyback on a pushbutton switch with a 3D printed cap held by a strand of wire.
...
Published on - 27th June 2012 15:31
Number of Views: 4358
Hi All!
Here is the code to create a voltmeter and ammeter. Everyone has a "display of choice" so you can use this to drive whatever display you wish to add. The color coding of the wires is only as a reference to make construction easier. I understand from Allegro that the ACS758 can handle as much as 200 amps and 72 amps is about maximum for this code. Hope this is of use and helpful to others.
Re: New project - MSFS C++ USB interface
The design is based on a classic switch (On/Off) but if I understand correctly, in special cases, the push button should be in a specific state and user is not allowed to change that.
Ioannis Yesterday, 21:38Ioannis