Companion Sheild
The entry level shield is labelled The Companion Shield. This is a PCB laid out in the pattern of a solderless breadboard. The holes are single sided, which means that components can easily be removed using solder mop braid, or a solder vacuum tool, if a mistake is made, or components need to be re-used.
The (PBP3) Companion Shield Manual iCan be downloaded from here
See the Companion Shield in our on-line shop
Re: Scanning encoder debounce on new scope
This can work just fine:
Ioannis Today, 06:571. Set up a timer interrupt at 10ms. Or even at 1ms and after ten int's do step 2.
2. Every interrupt read the buttons into the arrays. You can use a low priority...