I guess then, the sending device is interrupted by the USB routines while sending and as a consequence the transmission of RS-232 at that time is corrupted.
So I have a need to override a pushbutton (from ON to OFF) and came up with this concept; a solenoid piggyback on a pushbutton switch with a 3D printed cap held by a strand of wire.
...
By lowering the baud rate you're now allowing device B (and SERIN2) twice the time to receive the bits and assemble the byte.
That's probably what's helping a lot more than any line noise issue.
...
Published on - 13th May 2011 21:45
Number of Views: 6845
The attach zip contains a number of projects, the clock application is called "Clock_8_BIT_par_TFT.pbp" This project has a external RTC that can be set via USB with VB6.
There are a few other projects to drive this display including a SPI interface.
Disclaimer; I am not a programmer so my code may not be the most efficient.
Re: SERIN2 Receiving Wrong Data
I guess then, the sending device is interrupted by the USB routines while sending and as a consequence the transmission of RS-232 at that time is corrupted.
Ioannis Today, 11:35Ioannis