Here are my settings. Use it as a starting point.
#config
__config _CONFIG1, _FOSC_INTOSC & _WDTE_ON & _PWRTE_ON & _MCLRE_OFF & _CP_OFF & _CPD_OFF & _BOREN_ON & _CLKOUTEN_OFF & _IESO_OFF &...
Wish you to enjoy your new toy!
Regarding the modes and trigger it is necessary to read the manual. Every scope may have its own quirks.
Nice buy, at a nice price.
The fast rotation of the...
I have it set at 4.9V along the right edge of the screen. That's exactly the thing that I haven't totally figured out yet. Sometimes it's there, sometimes it's not.
When nothing displays, I...
If you don't know, read up on what Auto/Normal/Single mode actually does. Also, there's no indication of trigger level on the scope screen, where do you have that set?
HenrikOlsson Today, 07:10There's something hinky going on. Sometimes it won't scan the probes. I still haven't figured out what exactly.
But I go though the MODES, eventually the RUN/STOP buttons goes red, I reset it...
Thanks! I thought of rechecking my stuff a Nth time yesterday and noticed the coupling too.
All is well in the world.
:biggrin:
9674
I'd be more worried by the fact that signal swings negative and not positive :-)
Don't worry though, it looks like you have the input coupling set to AC on the scope. Set it to DC and try again.
Hi all !
I have a montage where I use 16F628A I/P with the settings below. Due to the price that has increased a lot and the unavailability (is it an older generation?) I would like to switch to...
SOLVED: Had probes set on AC coupling instead of DC coupling. D'OH!
I am scanning an EC11 rotary encoder wired according to Bourns debounce design using a Owon SDS1104 scope:
R1 = 10K
R2 =...
Re: Vevor SDS1104 4 channel scope
If you expect the signal to swing between 0 and +5V then set the trigger level to somewhere around 2.5V.
HenrikOlsson Today, 22:03As with input coupling the trigger coupling can usually be set to either AC or DC. Perhaps...