So I have a need to override a pushbutton (from ON to OFF) and came up with this concept; a solenoid piggyback on a pushbutton switch with a 3D printed cap held by a strand of wire.
...
By lowering the baud rate you're now allowing device B (and SERIN2) twice the time to receive the bits and assemble the byte.
That's probably what's helping a lot more than any line noise issue.
...
Tumbleweed, I had very strong suspicions that the issues were in the communication lines. I changed the Baud rate from 19200 to 9600 and I haven't got anymore wrong data at the receiver. I remember...
Ioannis, yes I'm doing data validation checks all the time. The first byte of the array is always 174. If this condition is not met, then the reading is discarded.
Re: New project - MSFS C++ USB interface
One of the suppliers that had quoted me for that switch with the red shaft has a model with 100gf to operate. The model I am testing now uses 330gf.
Demon Today, 03:51It would be easier to use that switch cause I...