Like this on a 16F18877?
ODCONC.6 = 0 ' Permit transmission (source current at will)
hserout [ ...message... ]
while TXSTA.1 = 0 ...
I've worked with the BMP180 with PBP, but not the BME280 IIRC.
Troy
Yeah, had Port instead of Lat.
https://www.picbasic.co.uk/forum/showthread.php/26614-Leaves-the-mainloop
I switched this to WDTE=OFF and it no longer resets.
(have some reading to do on...
PIC 16F18877
#CONFIG
__config _CONFIG1, _FEXTOSC_OFF & _RSTOSC_HFINT32 & _CLKOUTEN_OFF & _CSWEN_OFF & _FCMEN_ON
__config _CONFIG2, _MCLRE_ON & _PWRTE_OFF & _LPBOREN_OFF & _BOREN_ON &...
I "like" the 16F1937, but I have no allegiance towards it (I only have 15 on hand, I'll keep them for "something else"). :D I'm starting the slow/annoying process of choosing another PIC, with...
Demon Yesterday, 17:55Since the output on that specific chip will remain as driven output, and if you insist on using this, a crapy solution maybe to add a diode at the output before the pin is connected to the bus.
...
Thanks, I'll squeeze every drop out of it :)
It's just matter of curiosity, rather than actual need...
good luck getting the ternary operator to work with pbp
good luck getting pbp subroutines to return a value
just tick the box in the compile options
I asked to make corrections and he(or it?) created new code, this time with SWORD type variables
when I asked what kind is SWORD variables is, it answered that these are variables not supported by...
Re: Framing error if I disable transmitter after shift register is empty?
not really , why would you want to change it back and forth?
richard Today, 03:56is there a pullup for the tx line ?
post entire code snippets are nil value