I guess then, the sending device is interrupted by the USB routines while sending and as a consequence the transmission of RS-232 at that time is corrupted.
So I have a need to override a pushbutton (from ON to OFF) and came up with this concept; a solenoid piggyback on a pushbutton switch with a 3D printed cap held by a strand of wire.
...
By lowering the baud rate you're now allowing device B (and SERIN2) twice the time to receive the bits and assemble the byte.
That's probably what's helping a lot more than any line noise issue.
...
Published on - 31st May 2010 17:38
Number of Views: 5818
It's almost Olympics time... so here's a topical program using PBP exclusively (no embedded Assembler) to give you a Stop-Watch with 1/100th Second Timing (yes that's 0.01 of a Second) and gives you REAL-TIME display on your LCD. Now you can do your own timing and challenge the official time...
The program demonstrates using TMR1 in BACKGROUND (multi-tasking), uses PICBasic Interrupts, and accounts for the fact that PICBasic doesn't respond to those Interrupts immediately. There's also a set-Up CALIBRATION menu item, so you can adjust and calibrate your timer to an accuracy of 360mS per Hour.
How does it do all that? Better download the PDF and find out...
Melanie
PS. Questions and Comments post on this forum/thread. No off-list mail please.
Re: SERIN2 Receiving Wrong Data
I guess then, the sending device is interrupted by the USB routines while sending and as a consequence the transmission of RS-232 at that time is corrupted.
Ioannis Today, 11:35Ioannis