If you're using interrupts on either end then you shouldn't use SEROUT/SERIN as interrupts will upset the timing.
You should use the hardware HSEROUT/HSERIN routines, but then you will have to use...
I guess then, the sending device is interrupted by the USB routines while sending and as a consequence the transmission of RS-232 at that time is corrupted.
So I have a need to override a pushbutton (from ON to OFF) and came up with this concept; a solenoid piggyback on a pushbutton switch with a 3D printed cap held by a strand of wire.
...
Published on - 31st May 2010 17:24
Number of Views: 6039
Since this question has come up again, I thought I'd throw this module out to the masses. It is something I worked on a while back, with DT's help. Amid life's other priorities, it got put on the shelf to collect dust.
The basic idea is that by adding the module as an INCLUDE and inserting a couple of commands inside your code, you can have the PIC send timing data to your PC via the hardware serial port. It's made for 18F PICs (although some 16Fs may work too). You also need a timer that is not being used for anything else.
1) Instructions are included, as well as a small example.
2) It worked well for me, and as I recall, DT in testing.
3) Use it however you want.
4) I won't be able to offer much support, but figure there are enough knowledgeable folks around here that can help those who need it.
Re: SERIN2 Receiving Wrong Data
If you're using interrupts on either end then you shouldn't use SEROUT/SERIN as interrupts will upset the timing.
tumbleweed Today, 13:12You should use the hardware HSEROUT/HSERIN routines, but then you will have to use...