could do.........
1)
'
restarting:
pause 1000 ............... wait a second or 2 to reset all
@ RESET
'
or 2)................
if all slaves are on same 5 or 3 volt supply, then use a small...
you could do in software..... send out to one or all listeners a command to goto a restart routine like.... which "provides a way to execute a MCLR in software"
,
,
,
restarting:
@ RESET
Published on - 31st May 2010 17:24
Number of Views: 6138
Since this question has come up again, I thought I'd throw this module out to the masses. It is something I worked on a while back, with DT's help. Amid life's other priorities, it got put on the shelf to collect dust.
The basic idea is that by adding the module as an INCLUDE and inserting a couple of commands inside your code, you can have the PIC send timing data to your PC via the hardware serial port. It's made for 18F PICs (although some 16Fs may work too). You also need a timer that is not being used for anything else.
1) Instructions are included, as well as a small example.
2) It worked well for me, and as I recall, DT in testing.
3) Use it however you want.
4) I won't be able to offer much support, but figure there are enough knowledgeable folks around here that can help those who need it.
Re: Multiple PICs on usart network
Car automakers had to do it with better electrical characteristics I guess.
Ioannis Today, 07:00I'd also choose 2 wires USART classic setup. Tested and guarrateed to work just fine.
Ioannis