It seems to work fine with the serout2 software, but there's something off with hserout. It could be due to a difference in how numerical data is handled by these two types of software.
Best regands...
Thank you Demon
Valuable data
Appreciate.
OK, if you just want to see squiggly lines on the screen :-)
But you're not going to mess it up. It's part of verifying that it actually works as it should.
Compensating the probe, or at least...
I noticed that "rhythmic pulse" too. I figured it might be the breadboard.
I wanted to enjoy my scope for a few days before tweaking it and messing it up.
😄
Your waveforms seem to indicate that you might benefit from adjusting the trimmer capacitor on your probe(s).
HenrikOlsson - 11th June 2024, 17:21Darn tootin' right.
It's nice to finally use it as a diagnostic/testing tool. The scope has always been a mystery to me. I've always wanted to use one, but never had any electronics training. ...
What a magic tool Oscilloscope is, right?
Ioannis
I wanted to see just how sharp a Schmitt trigger could clean up a signal.
This is using a MR0102 with rocker actuator, followed by the Bourns RC debounce circuit, and then inverted with a...
This can work just fine:
1. Set up a timer interrupt at 10ms. Or even at 1ms and after ten int's do step 2.
2. Every interrupt read the buttons into the arrays. You can use a low priority...
Qualifying Compiler |
Upgrade Description | |
Upgrade PICBASIC PRO (PBP) 2.60 or later to PBP3 Gold Edition | ||
|
||
|
||
Upgrade PICBASIC Compiler (PBC) to PBP3 Silver Edition |
PBP and IDE/programmer
Hi,
robertg Today, 19:24Been many years since I've used PBP but back into it
Just upgraded from my 2011!!! PBP gold to the pro. and dusted off my pickit3
Downloaded PBP and installed fine.
But seems like not much...