From £34.95 |
Buy it Now Specifically for the 28-pin PIC® 14C000. |
Thank you Demon
Valuable data
Appreciate.
OK, if you just want to see squiggly lines on the screen :-)
But you're not going to mess it up. It's part of verifying that it actually works as it should.
Compensating the probe, or at least...
I noticed that "rhythmic pulse" too. I figured it might be the breadboard.
I wanted to enjoy my scope for a few days before tweaking it and messing it up.
😄
Your waveforms seem to indicate that you might benefit from adjusting the trimmer capacitor on your probe(s).
HenrikOlsson - 11th June 2024, 17:21Darn tootin' right.
It's nice to finally use it as a diagnostic/testing tool. The scope has always been a mystery to me. I've always wanted to use one, but never had any electronics training. ...
What a magic tool Oscilloscope is, right?
Ioannis
I wanted to see just how sharp a Schmitt trigger could clean up a signal.
This is using a MR0102 with rocker actuator, followed by the Bourns RC debounce circuit, and then inverted with a...
This can work just fine:
1. Set up a timer interrupt at 10ms. Or even at 1ms and after ten int's do step 2.
2. Every interrupt read the buttons into the arrays. You can use a low priority...
I also found the MAX6818 debouncer, but it's $4.37 for 8-bit at JLCPCB.
More like master of none. :wink:
Re: hserout issues on the 18F26K83
It seems to work fine with the serout2 software, but there's something off with hserout. It could be due to a difference in how numerical data is handled by these two types of software.
Chris777 Today, 12:34Best regands...