View Full Version : Warning Message[221]
markcadcam
- 15th September 2008, 22:25
When I compile my project I'm getting the 'WARNING[221] c:\pbp\18f452.inc 18 : Invalid message number (231)'
Does anyone know what this message is about? Is it anything I should be concerned with?
Thanks,
Mark
Bruce
- 15th September 2008, 23:55
Look at line 18 in your c:\pbp\18f452.inc file.
LIST p = 18F452, r = dec, w = -311, w = -230, f = inhx32
Kind of sounds like you might have 231 VS 230 in the line above?
230 supresses the aggravating message about __CONFIG has been
deprecated for PIC18 devices.
markcadcam
- 16th September 2008, 00:27
Hi Bruce,
That appears not to be the problem. I have checked my .inc file and that line looks like this - LIST p = 18F452, r = dec, w = -311, w = -230, f = inhx32
Mark
mackrackit
- 16th September 2008, 07:21
Post your code and all of the inc file.
If I remember correctly there is not an error code 231. We will need to see what is being compiled to figure this out.
Bruce
- 16th September 2008, 07:45
Which version of MPASM are you using?
markcadcam
- 16th September 2008, 15:01
Bruce,
That was the problem, I was using an older version. Works fine now with the new version.
Thanks,
Mark
Powered by vBulletin® Version 4.1.7 Copyright © 2024 vBulletin Solutions, Inc. All rights reserved.