View Full Version : PIC18F97J60 max external bus speed
mariusv
- 30th May 2008, 00:00
I've just managed to get this device working with external flash memory. I don't have timing diagrams of the external read and write cycles for the PIC, so tough to say what max bus speed I can operate at. I did see a comment in AN869 that the ext. bus speed is limited to 25MHz.
Can anyone shed some light on this please?
Mariusv
skimask
- 30th May 2008, 01:58
I don't have timing diagrams of the external read and write cycles for the PIC, so tough to say what max bus speed I can operate at. I did see a comment in AN869 that the ext. bus speed is limited to 25MHz.
Internet connection works...otherwise you wouldn't have been able to post a question.
Is Microchip's website down?...otherwise you'd most likely be able to find the PIC18F97J60 datasheet possibly by searching for PIC18F97J60, or you might even click on this link:
http://www.microchip.com/stellent/idcplg?IdcService=SS_GET_PAGE&nodeId=1335&dDocName=en026439
But since you've come this far and as you say, you have an example working with external flash memory, I think I can safely assume you know this already. I got the answer in less than a minute (excluding the download of the entire datasheet).
mariusv
- 3rd June 2008, 18:49
Thanks for your wonderful help, Skimask.
I did find the datasheets, and it seems that the address valid to valid data time constraint was the most severe requirement. Using 70ns flash devices, I calculated that I could use a bus speed of 31.5MHz. However, the datasheet states that a bus speed of 25MHz should be used with external program memory.
Has anyone done similar calcs?
Thanks in advance
Mariusv
skimask
- 3rd June 2008, 19:16
However, the datasheet states that a bus speed of 25MHz should be used with external program memory.
I can't find that 'requirement' in the datasheets.
Where are you seeing that?
Powered by vBulletin® Version 4.1.7 Copyright © 2024 vBulletin Solutions, Inc. All rights reserved.