Writing, Reading from Internal PIC EEPROM

[NO2K]

I'm using a 16F870, PIC Basic Pro ver 2.47, Microcode Studio Plus ver 3.0 and a programmer from KitsRUs.com (DIY 149 B) The code as follows:
WRITE 0, B.btye0
WRITE 1, B.byte1
where I am asking the code to write to eeprom location 0, B (one of my program variables), the first byte
and the second byte to eeprom location 1

the code compiles with no problems, but when I try to use the programmer I get this error:
EEPROM error at 0x0000
Good 0xFF
Bad 0x0C

Would someone tell me what that means and how can I make it work.
I did search all the forum for this answer, but seems my problem is unique

Any advice would be greatly appreciated!

[mister_e]

I think the problem is due to you KIT software. Which one are you using? Which version?

[mackrackit]

Read down to post 12 here
http://www.websitetoolbox.com/tool/post/diykit/vpost?id=372891&highlight=eeprom
This seems to be a common problem for this setup.

[NO2K]

Thanks to Mister e and to mackrackit for your responses! The version I am using is KIT 149B. After seeing all the comments on mackrackit's thread, it would appear I should be asking Bob Axtell the fellow who is working for KitsRUs.