F1CHF
- 26th October 2006, 12:52
Hello,
I didn't find any explanations about BUTTON command, so :
in the help I see
BUTTON Pin,Down,Delay,Rate,BVar,Action,Label
question:
Tell me if I can use this Command for this need.
Assume that somebody depress a DTMF unit, so I am aware of a code is
present looking to the STROBE input of a MT8870 for example.
I need to DO a ONE step (right or left depending of the DTMF code)
and if the guy is maintaining the DTMF strobe... let say after 500 ms
I will continue to send Right or left order(s) to the Servo motor.
and as soon the button is released, I will return to the main routine
waiting for a new DTMF.
Is the button command can help me ?
if fact i do not really understand the meanning of autorepeat and the Action
label interraction.
Thanks in advance for your good support.
Francois
I didn't find any explanations about BUTTON command, so :
in the help I see
BUTTON Pin,Down,Delay,Rate,BVar,Action,Label
question:
Tell me if I can use this Command for this need.
Assume that somebody depress a DTMF unit, so I am aware of a code is
present looking to the STROBE input of a MT8870 for example.
I need to DO a ONE step (right or left depending of the DTMF code)
and if the guy is maintaining the DTMF strobe... let say after 500 ms
I will continue to send Right or left order(s) to the Servo motor.
and as soon the button is released, I will return to the main routine
waiting for a new DTMF.
Is the button command can help me ?
if fact i do not really understand the meanning of autorepeat and the Action
label interraction.
Thanks in advance for your good support.
Francois