View Full Version : Proteus Execute Error
pramarn
- 4th October 2006, 12:39
I create project drilve GLCD use picbasicpro compile asm file and put to proteus 6.7 after i run it show this Error.
This Error is because source code or proteus 6.9 ?
can you help me for fix this error?
Thankyou
sayzer
- 4th October 2006, 13:18
It seems you are having an issue with Proteus configuration. Your code has been compiled succesfully.
So for sure, it is not about your code.
srspinho
- 4th October 2006, 17:54
Hi Friend,
Is the "RV1" (in your circuit) a potentiometer or something like that ?
please, check if the RV1 component you´re using has a spice model for the simulation. Sometimes you can put the componnent in your design but it doesn´t have a spice model...
regards.
Sérgio
pramarn
- 6th October 2006, 04:09
Thank you for help
I can fix that error but now i found New error in simulate program
after I buil program and Load Myprogram.Hex to MCU and Select Execute
It not happen CPU load is 0%. How to fix this Error?
Please help thank You.
keithdoxey
- 6th October 2006, 08:51
Have you tried asking on the Proteus Support Forum ?
http://support.labcenter.co.uk/forum/
Labcenter staff are always on the board so you should get an answer pretty quickly. Although I have been using Proteus since V4.6 I have never used the simulation features. I just use if for ISIS (Schematic) and ARES (PCB Layout). You really need to ask on the proper forum as projects sometimes cant be loaded if they were created in a newer version of Proteus and I am running 6.3 SP2 but the current version is 6.9
Your problem seems to be a Proteus one rather than PicBasic.
Powered by vBulletin® Version 4.1.7 Copyright © 2025 vBulletin Solutions, Inc. All rights reserved.