View Full Version : Pulsein issues...
cpayne
- 4th April 2006, 15:55
I am using a pulsin to read RC signals. I am using a 18F2220. It works fine with a HiTec Radio hooked up to it. I can't get it to work with a Futuba. I put the futuba and and hitec on the scope, they are exactly the same width, the only difference is the futuba is 3V peak, and the HiTec is 3.3. Theu are both above the threshold, right? It will work with the Futaba on port C3, A6, A7, and A5, not on port C2, C1, C0. I really need it to work on C2, C1, and C0, I already have board made and need to read 7 channels. It worked fine with the HiTec, but now I'm struggling with the Futuba.
Thanks
Acetronics2
- 4th April 2006, 16:42
Hi, Payne
Do not use a schmitt trigger input or build a level adapter ...
Alain
cpayne
- 4th April 2006, 18:26
OK. I jumpered to some spare TTL inputs and that seemed to fix it. It works pretty reliable on one of the Schmitt triggers. What if I just power the PIC with 3.3V, will that fix the issue?
Acetronics2
- 4th April 2006, 18:29
I'd forgotten to suggest you !!!
Alain
Funky Gibbon
- 4th April 2006, 18:45
Hi,
Are you using a pullup resistor on the input? the upper voltage doesn't really matter 3v, 3.3v ot 5v so long as you can get a definate logic high and logic low
Shaun
Powered by vBulletin® Version 4.1.7 Copyright © 2025 vBulletin Solutions, Inc. All rights reserved.