blake
- 28th March 2006, 23:50
Hi,
Sorry this question has been asked loads of times but here it goes. I'm using 18F452 on PICDEM 2 Plus x by 2. Just some really silly questions. I want to get these 2 communicating. Well 1 transmitting data (NMEA) and the other receiving. To actually connect them can I just put a wire from RC6/TX straight into the other PIC RC7/RX (also on another PICDEM board) is it as simple as that or am I just simple thinking that. Any code that might help would be appreciated also.
Regards
Blake
Sorry this question has been asked loads of times but here it goes. I'm using 18F452 on PICDEM 2 Plus x by 2. Just some really silly questions. I want to get these 2 communicating. Well 1 transmitting data (NMEA) and the other receiving. To actually connect them can I just put a wire from RC6/TX straight into the other PIC RC7/RX (also on another PICDEM board) is it as simple as that or am I just simple thinking that. Any code that might help would be appreciated also.
Regards
Blake