Gathering chip temperature from PIC18F26K83

[rocket_troy]

I have an application where I'd like to gather approximate internal chip temperature from a PIC 18F26K83. From the datasheet this requires looking up calibration data stored on the processor as part of the process. That data appears to be stored in a thing called the Device Information Area (DIA) not in specific readily accessible registers. So, my question is: to gather that data, do I use a PEEK command and use the relevant address listed in the datasheet table at the address used for the Peek statement?

Thanks,

Troy

[richard]

it looks to be pretty much the same as for any of the non volatile memory for that chip


10004



once region is set


10005

[rocket_troy]

Okay, thanks Richard. I was really hoping to avoid assembly, but it is what it is.

Troy

[rocket_troy]

Thanks again for that Richard. I'm discovering the only assembly instruction I really need as an assembly call is the table read command. Everything else (reading & writing to registers) can be done in Pic Basic.

Cheers,

Troy