rayzrocket
- 30th October 2013, 14:01
Typical stepper motor driver boards at robotic sales shops have command inputs of 'dir' and 'step' ; where 'step' needs to be ~10Hz upto ~10khz.
Is it possible to use 'SOUND' for the step command to the driver?
How taxing is 'SOUND' on the PIC? (I'm using PIC161826 @32Mhz intosc), I would like to have two channels of stepper motor control.
Has anyone already done this?
(BTW, don't tell me I'm stupid, I already know that)
Is it possible to use 'SOUND' for the step command to the driver?
How taxing is 'SOUND' on the PIC? (I'm using PIC161826 @32Mhz intosc), I would like to have two channels of stepper motor control.
Has anyone already done this?
(BTW, don't tell me I'm stupid, I already know that)