tomadarpel
- 30th May 2013, 09:55
hi everybody, i m new in the forum!
i have a problem with my pic18m2 and display LCD. i don t fully understand the code written in the picaxe manual 3, but i thought giving the enable signal would switch on he display..
could someone give me a code to switch on the display or write "hello"?
i have only he LCD display connected with 6 pins to the pic (RS, EN, DB4 DB5 DB6 DB7)
the display doesnt seem to switch on the light even if i put 0 and 5 volt on the right pin! it s normal? does it need enable command?
please help me, i m a noob of electronics :)
i have a problem with my pic18m2 and display LCD. i don t fully understand the code written in the picaxe manual 3, but i thought giving the enable signal would switch on he display..
could someone give me a code to switch on the display or write "hello"?
i have only he LCD display connected with 6 pins to the pic (RS, EN, DB4 DB5 DB6 DB7)
the display doesnt seem to switch on the light even if i put 0 and 5 volt on the right pin! it s normal? does it need enable command?
please help me, i m a noob of electronics :)