How can I clean up my code?

[Christopher4187]

I have a program where I'm sending three numbers out of the UART port. An example would be:

in1 - 10
in2 - 20
in3 - 5

On the transmitting side, the code is short and works fine. One the receiving side it's very inefficient. It seems like the case/select case would work better but I can't figure out how to implement it correctly. When I receive the numbers, it goes like this:


if b1=0 and b2=1 and b3=11 THEN GOTO ON1
if b1=0 and b2=1 and b3=12 THEN GOTO OFF1
if b1=0 and b2=3 and b3=11 THEN GOTO ON2
if b1=0 and b2=3 and b3=12 THEN GOTO OFF2
if b1=0 and b2=6 and b3=11 THEN GOTO ON3
if b1=0 and b2=6 and b3=12 THEN GOTO OFF3
if b1=0 and b2=5 and b3=11 THEN GOTO ON4
if b1=0 and b2=5 and b3=12 THEN GOTO OFF4

How can I get the PIC to just look at the three numbers and execute automatically, if that's possible? I have to sort through almost 100 different number combinations and the code is taking up way too much space. Is there an easier way?

[Archangel]

Use Select Case, check the value in B0 and go as you need to to check b1 and again direct until you check variable b2 OR
use 3 lookup tables to direct your code