ecoli-557
- 10th January 2012, 20:39
Hello All, I am going to try the new PBP3 with the MCSPx and try my luck using the compile ICD option so I can debug my code easier. In doing so, the project I am trying to do also uses a serial port.
The primary serial port will be used for debug on MCSPx and the 2nd serial port will be used for communication via RS485.
So, I have used DT's Instant Interupt before (nice job!) but the chip I plan on using is the 16F1527 and it has 2 EUSARTS, do I brave fiddling with the venerable code inside DT-INTS-14 to see if I can get it to look at the 2nd serial port? Or is there a better way? Clearly I would prefer another way as I don't want to disturb something that works <grin>.
I must use the 1st serial port for the debug and the 2nd serial port for the 485 communication, design already cut.
I am using PBP3, MCSP5 and DT-INTS 1.10
Happy New Year to All,
Steve
The primary serial port will be used for debug on MCSPx and the 2nd serial port will be used for communication via RS485.
So, I have used DT's Instant Interupt before (nice job!) but the chip I plan on using is the 16F1527 and it has 2 EUSARTS, do I brave fiddling with the venerable code inside DT-INTS-14 to see if I can get it to look at the 2nd serial port? Or is there a better way? Clearly I would prefer another way as I don't want to disturb something that works <grin>.
I must use the 1st serial port for the debug and the 2nd serial port for the 485 communication, design already cut.
I am using PBP3, MCSP5 and DT-INTS 1.10
Happy New Year to All,
Steve