Anyone mess with the WIZnet110SR serial to Ethernet boards? Using the WIZnet software, I can use my laptop to successfully send data through it(to a 2x16MEL char display) and ping it. But if I try to use the supplied WIZnet program to tell it to connect to (for example) 192.168.1.137 (another Ethernet board on a LCD),,, it just reports (on the serial debug line) "Listen OK", and then "closed".

If I try to ping the WIZnet board on another computer (linux) on the network, it not there. The IP address of the WIZnet board is 192.168.11.1. The WIZnet board only seems to exist using the WIZnet software. Can that be? Pinging my other LCD Ethernet adapter (at 192.168.1.137) works fine from the Linux computer.

My end goal is to setup the WIZnet board to allow a PIC serial board to send specific commands through a network to a specific LCD TV . Can anyone shed a little light on this?
Thanks,
Jim