Hello, welcome to our forum.

It looks like you have registered but you have not yet posted and messages. Our requirements are that you must post at least two messages, to allow the moderators to review your registration, before you will be allowed access to the full range of forum areas.

Please make a couple of posts, until then you may see a notice that says you are banned from certain forum areas.


Thank you.

Remove Text Formatting
Loading...

+ Reply to Thread
Results 1 to 2 of 2
  1. #1
    Join Date
    Jan 2012
    Posts
    13

    Default can anyone tell me what is the pulse width required for turnigy TG9e servo motor

    i have this servo motor but i do not know the exact pulse width which i must provide for proper working of this servo motor.
    i need it to move to particular angles based on my requirement.
    so can anyone help me

  2. #2
    Join Date
    Feb 2006
    Location
    Gilroy, CA
    Posts
    1,530

    Default Re: can anyone tell me what is the pulse width required for turnigy TG9e servo motor

    Name:  servo.jpg
Views: 1395
Size:  27.2 KB

    All hobby servo's work roughly the same. The exact angle will differ slightly on each one. Above shows the basic signal vs degrees. Most servo's will accept a 50 hertz pulse (pulse every 20 ms) with duration of .9 ms to 2.1 ms, with a "neutral" at 1.5 ms.
    http://www.scalerobotics.com

Members who have read this thread : 0

You do not have permission to view the list of names.

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts