Pickit2 message unknown


+ Reply to Thread
Results 1 to 2 of 2
  1. #1
    Join Date
    Nov 2008
    Location
    sao paulo - brasil
    Posts
    23

    Default Pickit2 message unknown

    I am using the 18F4620 and When I call the file in the pickit2 him of the the following message:

    Some configuration words not in Hex.file
    Ensure default values above right are acceptable

    what should make?

    in advance thankful,

    vicente

  2. #2
    Join Date
    Nov 2003
    Location
    Wellton, U.S.A.
    Posts
    5,924

    Default Re: Pickit2 message unknown

    Just as it says,
    You have defined all of the available config settings and the ones that you did not define will be set to their default.
    To make the message go away use all of the configs, but normally this is not a problem. Just check and see if the defaults are OK.
    Dave
    Always wear safety glasses while programming.

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts