Hi guys ,
I was working on a problem that required that i review my config1 and config 2 word settings for this chip and could not see what the setting would be using PBP3 for the following options ,
if someone can advise / confirm on the ones with a ??? next to them
Cheers
Sheldon
Config1 word
------------
' bit 10-9 BOREN<1:0>: Brown-out Reset Enable bits(1)
'--------------------------------------------------
' _BOREN_ON = 11 = BOR enabled
' _BOREN_?? = 10 = BOR enabled during operation and disabled in Sleep
' _BOREN_SBOREN ??= 01 = BOR controlled by SBOREN bit of the BORCON register
' _BOREN_OFF = 00 = BOR disabled
' bit 4-3 WDTE<1:0>: Watchdog Timer Enable bit
'---------------------------------------------
' _WDTE_ON = 11 = WDT enabled
' _WDTE_??? = 10 = WDT enabled while running and disabled in Sleep
' _WDTE_SWDTEN ?? = 01 = WDT controlled by the SWDTEN bit in the WDTCON register
' _WDTE_OFF = 00 = WDT disabled
CONFIG 2 WORD
===============
' bit 12 DEBUG: In-Circuit Debugger Mode bit(2) *** See Notes ***
' ---------------------------------------------
'1 = In-Circuit Debugger disabled, ICSPCLK and ICSPDAT are general purpose I/O pins
'0 = In-Circuit Debugger enabled, ICSPCLK and ICSPDAT are dedicated to the debugger
No setting required default is 1 ?????
'bit 1-0 WRT<1:0>: Flash Memory Self-Write Protection bits
'---------------------------------------------------------
' _WRT_OFF = 11 = Write protection off
' _WRT_?? = 10 = 000h to 1FFh write-protected, 200h to FFFh may be modified by EECON control
' _WRT_?? = 01 = 000h to 7FFh write-protected, 800h to FFFh may be modified by EECON control
' _WRT_ON = 00 = 000h to FFFh write-protected, no addresses may be
Bookmarks