Looking for ideas to eliminate chattering of my relays that are activated depending on the ADvalue that is read from the analog input.
The Analog value is filtered through DT_Analog module (Analog oversampling to 12 bits).
But on the decision point, relays are chattering on/off as the analog value is slow changing.
Any ideas?Code:gosub getADC 'ADvalue=abs (ADvalue-818) if ADvalue < upper then relay.0=1 else relay.0=0 endif if ADvalue < mid_upper then relay.1=1 else relay.1=0 endif if ADvalue < mid then relay.2=1 else relay.2=0 endif if ADvalue < mid_lower then relay.3=1 else relay.3=0 endif if ADvalue < lower then relay.4=1 else relay.4=0 endif
Ioannis
Bookmarks