Hi,
i want to comminicate with 18F452 to PC Visual Basic. but i think my problem is OSC . Coz i m using 10 MHZ Quartz and with PLL so 40 MHZ OSC... Maybe it doeasnt senkron.
if had any project pls send me.. or same project...
Thanx already now...
Hi,
i want to comminicate with 18F452 to PC Visual Basic. but i think my problem is OSC . Coz i m using 10 MHZ Quartz and with PLL so 40 MHZ OSC... Maybe it doeasnt senkron.
if had any project pls send me.. or same project...
Thanx already now...
I would suggest you check everything in simple block and step by step
1. Simple led blink or PWM : This will confirm your configuration fuse and OSC setting are fine
2. Use low baudrate 2400-9600 baud and dump some text string to your PC using Hyperterminal or MicroCode Studio Serial communicator.
3. read the simple VB6 tutorial bellow
http://www.rentron.com/VisualBasic.htm
4. post the whole project (PIC code, config fuses, VB code and schematic) here.
good luck
Steve
It's not a bug, it's a random feature.
There's no problem, only learning opportunities.
This program steps working... only comm not worked. i ll send it... ok. Thanx..
Hi,
a while back i did a really nifty terminal example. Maybe this would help to start
http://www.picbasic.co.uk/forum/showthread.php?t=1833 see post #4
HTH
Steve
It's not a bug, it's a random feature.
There's no problem, only learning opportunities.
Bookmarks