I'm going to be working on a project that looks at a byte of data from a serial connection and displays a word in response to that data on an LCD.
I'm LCDOUT novice so bear with my basic questions.
In intend on displaying different words at different cursor locations on the LCD...
bit0 = LCDOUT $FE, $80, "WORD"
bit1 = LCDOUT $FE, $80 + 10, "WORD2"
etc.
It looks as though you have to clear the entire LCD before writing updated information to it? ($FE,1)
Is there any way you can clear just one line at a time?
Not that it would matter, I suppose, if it cleared and displayed quickly
enough.
Also, are there a lot of complications in using (2) LCD displays on one pic? Would you just run all the data lines in parallel and then do a "select LCD1 or select LCD2"?
Thanks.
--Mike
Bookmarks