Hello guys,
I am looking for a way to measure the battery voltage (0-12v) using pic16f628.I search in the forum and I find the way using a POT and ADC pin.
My PIC does not have ADC!!!!
Any other suggestion?
Thsnks
Hello guys,
I am looking for a way to measure the battery voltage (0-12v) using pic16f628.I search in the forum and I find the way using a POT and ADC pin.
My PIC does not have ADC!!!!
Any other suggestion?
Thsnks
Hi,
Take a look here :
http://www.picbasic.org/forum/showthread.php?t=5327
But my penny's worth, either go for an external ADC or choose a PIC with ADC's.
Regards,
sda
Hi, N'geron
there's a way to do it with a simple 16F84 an the RC Time command ...
look :
first : connect a resistor between your voltage to be mesured and the input port. a capacitor between input and ground.
second : make your input a 0 v ... output
Third: make the input ... an input with RCTime and measure the time to go up from 0v to the pic transition input voltage (1.5v) ...
so, time = - RC Log ( 1.5/ Vbatt ) ...
a small lookdown table will easily translate time to voltage, if needed.
of course, you must reduce your batt voltage to fit into the 0 - 5 volts range or use a zener not to exceed the Pic input range.
not so precise as an ADC ... but useful here.
Alain
************************************************** ***********************
Why insist on using 32 Bits when you're not even able to deal with the first 8 ones ??? ehhhhhh ...
************************************************** ***********************
IF there is the word "Problem" in your question ...
certainly the answer is " RTFM " or " RTFDataSheet " !!!
*****************************************
Hi ngeronikolos,
Another way might be to use the Comparator Module of the 628.
After reducing the voltage with a pair of resistors, apply it to 1 input of a comparator.
Then using PWM output on another pin (filtered with a resistor and capacitor), adjust the DutyCycle to control the analog voltage being applied to the other comparator input.
Then when the comparator changes state, you know what voltage it was at.
Not the best resolution, but it should be good enough to tell if the battery's getting Low or not.
<br>
DT
Goodmorning boys,
I have just bought an etxternal ADC tlc549 8Bit resolution A/D converter.
Can you please let me know whickh is the next step?
Two resistors connected in Series,one point connect to the Supply to be measured and the other to Vss (0v).The junction to the ADC.
Please can someone help me?
Bookmarks