Hello everyone. How to communicate with Nextion Lcds using PBP ??? Link: https://www.itead.cc/wiki/Nextion_HMI_Solution
Hello everyone. How to communicate with Nextion Lcds using PBP ??? Link: https://www.itead.cc/wiki/Nextion_HMI_Solution
You control the LCD through TTL RS232 (only Tx and Rx needed).
Also you must ensure good +5V/1A to the LCD.
The rest on the users manual.
Ioannis
Hello Ioannis, thank you for the feedback.
I did not find examples for PBP on the internet. In the manual there are only examples for uses with Arduino and RaspBerry Pi.
I could not convert the command used in Arduino to be used in PBP.
My question is about the serial command format to use.
Thank you for any help.
From what I can gather it uses a serial connection - so have a look at serial examples for PBP and then adapt them to send the instructions to the device. There is an example here http://support.iteadstudio.com/suppo...cs/11000012477 where someone is using an arduino without any library files, which may help
You should be able to used hserout command with a PIC that has a UART serial port (most do)
I also ordered a module, waiting for delivery. Meanwhile, I've downloaded their IDE. Looks like Visual Studio, but so far, I have not managed, how to put my own text on label Very alogical design...
Mike's tutorial on Nuts n Volts is good starting point.
Also the tutorials on YouTube are very helpful. There are many that take you step by step.
Ioannis
Bookmarks