5V to 3.3V communication

[MOUNTAIN747]

I’m trying to use SHIFTIN between a 16f1936 at 5V and a 3.3V MAX31855 T-type TC to digital converter.

Question: What is the most common method for communication interface of a 5V device with a 3.3V device? There are three lines between the PIC and the converter. I didn't think about the problem until I could not communicate with two MAX31655 which means I may have smoked 'em.

Select 5V from PIC needs to be 3.3V I think
CLK 5V from PIC needs to be 3.3V I think
Data 3.3V from MAX should be OK

The PIC drives the Select line from high to low enabling the converter serial output. The PIC supplies the clock and the converter drives the data line as communication is only one way from the converter to the PIC. Will a 1k ohm resistor in the CLK line create any problems? Will a 1k ohm resistor in the Select line cause any problems? The Data line is being driven by the 3.3V converter and should not have any problems, PIC should be able to read 3.3V and lose no data.
Comments please!

Wayne

[tumbleweed]

Select 5V from PIC needs to be 3.3V I think
CLK 5V from PIC needs to be 3.3V I think

Yup. You should use more than just a series 1K resistor, though.
You could use a voltage divider on the 5V PIC outputs...say 2K series/3K shunt to gnd. That should work ok at slow speeds.
You could also use a pullup resistor to 3.3V and drive the outputs as open-drain, but that's not compatible with SHIFTIN.

Data 3.3V from MAX should be OK

For the input pin be sure to pick a pin that has TTL level inputs (PORTA and PORTB) and not ST levels, otherwise the 3.3V output from the MAX won't meet the input Vih spec.

[HenrikOlsson]

Hi,
There are bidirectional level shifter ICs available and you can do it with small MOSFETs and such but for a one-off I'd just use a voltage divider on the 5V to 3.3V signal and nothing on the 3.3V to 5V signal. (Doing that right now in my desk (PIC is 3.3V, device is 5V).

The MAX31855 logic high is min Vcc-0.4 so if you run it at 3.3V it'll put out 2.9V which is well above the 2.0V threshold of the PIC if you run that at 5V and using a non Schmitt trigger input...

/Henrik.

[MOUNTAIN747]

Thanks guys,
I will take that and run with it. I think I'll bread board with the 2k/3k then look at a level shifter IC's' on the finial board work.
Thanks again!
Wayne

[MichelJasmin]

Check out at Adafruit's breakout board. They have a nice solution: https://github.com/adafruit/Adafruit...breakout-board

Why not powering your PIC with 3.3V? That saves a lot of trouble.

[Dave]

Rather than buying expensive chips why not make your own with this app note:

[MichelJasmin]

Rather than buying expensive chips why not make your own with this app note:

The Adafruit board is quite pricey but look how they did the level shifting. I did use this trick with an ESP8266, worked fine.