Labcentre Proteus Simulation software question

[financecatalyst]

Is there any way to provide voltage to the ADC manually while the simulation is running? Upto now I always give voltage using a battery and I have to stop the simulation to change the battery voltage so I can see the ADC result which is very annoying.

I also tried it with an active potentiometer, but the steps are too big.

[Darrel Taylor]

Are you using the POT-HG or the normal POT?

POT-HG is a (High Granularity) version that has 1% steps.

You can also use the Function Generator set to 0 Hz, then adjust the amplitude.

[financecatalyst]

Thanks. Do you know any way where I can provide a minimum 0.5V and then increment 1.22mV on top. I have tried a few ways but couldn't do it precisely.

[Darrel Taylor]

You could use one of the 12-bit DAC's, which gives 1.221mV steps.

A second PIC in the the .dsn with a couple buttons to control it should work.

[Darrel Taylor]

Here's an example that gives two 12-bit analog voltages using a DAC.
A Virtual Terminal is used to set the voltages.

http://support.melabs.com/threads/28...replaces-pots)