How to Read r/c signal PCM

[jetpr]

Hi all
i need help to read PCM signal and scale from 0 to 100%

[Acetronics2]

Hi, jet

Pulsin seems to be very adequate ...

@ 4 Mhz result will be ~100 to ~ 200 ...

100 is 0% 200 is 100% ...

@ 20 Mhz ...............~ 500 to ~ 1000

then just calculate the y = ax+b equation ...

But if you want to have precise 0% for stick down and 100% for stick up , you'll have to calibrate and memorize result first.

i.e 112 is 0 % and 188 is 100% @ 4Mhz

May be you will have to use DIV32 for calibration if 20 Mhz necessary for 2µs resolution ( see manual ...)

Alain

[jetpr]

I need a specify pin to connect the rc input to read PCM or not

[Acetronics2]

Hi, jet

I Think the best for you could be to learn the Melabs or Parallax Basic manuals from the beginning.
Jet models will have to wait some time ...

Alain